 Vacuum blower
finely tuned to the various sizes of the VacuPowerlift in the following designs:
SKE 2,2-0070 (2,2 kW)
SKE 3,3-0070 (3,3 kW)
SKE 4,0-0120 (4,0 kW)
Silencer box
for all blowers. Reduces the noise level to less than 65 dB(A) and thus supports the ergonomy at the work place
 Remote control
with pocket sender for wireless on/off control of the blower. Recommended if the blower is not placed near the tube lifter
 Dust filter
to protect the blower from dust particles. Low maintenance with exchangeable cartridge.
For highest filtration demands a dust filter with steel container and larger insert is available.
 Operation with tilting lever
The
control is by pulling the lever up or down. This design allows to
adjust the height of the lifting tube both with or without load via
adjustment screws.
 Extension
Available
in two different standard lengths (250mm and 500mm). Large goods can be
handled more ergonomically. On request also available with special
lengths.
 Angle adapter for lever
This
joint can be either used directly or in connection with an extension
and allows the handling of loads that are located higher up. The angle
can be adjusted by screws.
 Additional handle
The
additional handle at the rear is mostly used when handling sacks or
small format loads. This handle allows to operate the Powerlift with
both hands and thus a very fast and strong engagement of the respective
loads.
 Quick-change coupling
The quick-change coupling allows to use different suction feet on the same VacuPowerlift. Within seconds the feet can be changed. This allows to handle different workpieces with the same lifter.
 Turning feature
Suitable for turning workpieces while the handle stays in the same position, e.g. when boxes are stacked at different angles
 Manual swivel feature
This
swivel feature allows to move workpieces from the horizontal into the
vertical position and vice versa. This feature is strictly manual
without any stops.
 Pneumatic swivel feature
Engage
- swivel - set down without muscles. This swivel feature is operated
strictly pneumatically by a hand-controlled valve. The cylinder can be
stopped in any position.
 Single suction foot in round design for barrels, stones etc.
 Double suction foot for cardboard boxes, plates and larger bodies
 Fourfold suction foot for cardboard boxes, extensive parts and slabs
 Special suction foot for the handling of transport boxes
 Suction foot for sack lifting
|
